Application features of dynamic memory devices based on binary fiber-optic structures are researched in optimal filters of sequence of pulse signals.
The possibility of significant improvement of signal-to-noise ratio in optimal filters of sequence of pulse signals using non-recirculating binary structures compared to recirculators is proved.
Application of the technical solution based on the method of enhancing identity copies in binary fiber-optic structures allows to achieves the gain in signal-to-noise ratio of about 37 dB for 4096 copies processed, this corresponds to the gain of 22 dB compared to typical recirculator.

Keywords: binary fiber-optic structure, optimal filter, pulse sequence, signal-to-noise ratio

Coding of information using of pseudo-random sequences  in quantum communication systems providing an operation with a low probability of single-photons detection is proposed. The results of statistical modeling of information extraction from the bit stream, received at different specified probability of detection based on the correlation properties of the M-sequences are demonstrated. It's demonstrated that the peak value of cross-correlation function for the M-sequence of 255 bits is on the average more than 2 times higher  than the level of side lobes at the probability of single-photons detection 20%.

Keywords: quantum communications, single-photon detector, maximum length sequence

Thermal treatment of Fe-Co-V as an instrument to improve soft-magnetic material devices quality
The process of optimizing the thermal treatment Fe-Co-V alloys used in the magnetic torque motors is studied in order to improve the magnetic properties. It is shown that to achieve high and stable magnetic properties of the alloy it must be annealed in vacuum using inactive coatings. Regime of the annealing process depends on the quality of the original alloy. Quality verification is carried out by measuring the magnetic properties of the control samples . Identifying optimal annealing regime is based on the analysis of a phase diagram of Fe-Co alloy. In connection with that the research of influence of the heating rate , maximum temperature and holding time , cooling rate on the behavior of the magnetic parameters of the control samples is carried out. It was found that the improvement of the magnetic properties is achieved by increasing the exposure time to 6h at the cooling rate of 100 °/hr. As a result a reduction of the coercive force (60 ÷ 50 ) A / m to (28 ÷ 32 ) A / m and increased magnetic induction of technical saturation from (2,0 ÷ 2,10) Т to (2,20 ÷ 2.26 ) T. for Fe-Co-V alloy are achieved. Research of the exposure time and the cooling regime caused a decrease in coercive force of the Fe-Co alloy.

Keywords: Heat treatment , the annealing conditions , Fe-Co-V, technical saturation induction , the coercive force

By self-propagating high-temperature synthesis (SHTS) prepared fine powder оf La2-xSrxNiO4 composition , which is used to obtain dense ceramics exhibiting the properties of n-type semiconductor. Prolonged annealing of the samples resulted in a decrease of the conductivity on the order of 3-4, and the changing nature of the dielectric spectrum: dielectric constant ε' has a stable value of 4·104 Hz in the range of 0,4 − 1·105 Hz .

Keywords: dielectric constant, phase separation, nikelate of strontium lanthanum, self-extending high-temperature synthesis

According to the signal theory vocal speech presents a non-stationary random process due to time variation of its main characteristics. A special emotional impact is gained during ensemble and choir performances. The article provides the correlation analysis results and the autocorrelation function of ensemble singing calculated, taking into account the non-stationary nature of acoustic signals. The studies have shown that there is a certain visual resemblance between correlation portraits of a non-professional student ensemble and a non-professional solo singer. At the same time the correlation portrait of student and professional co-performance tends to a professional singer correlation portrait. This helps to make a quantitative assessment of an ensemble’s professionalism which, alongside with a vocal teacher’s subjective assessment, can provide an objective view on singers’ voices condition to optimize the academic voice training process in an ensemble, which is important when using this voice assessing method in music schools, colleges and universities.

Keywords: Vocal speech, acoustic signal, ensemble singing, choir performance, non-stationary random process, autocorrelation function, quantitative assessment

Based solutions of avalanche transit diode amplifier for under the influence of microwave amplitude- modulated optical signal at the p-n junction diode is determined by the response of the amplifier , while a detector device characteristic. We investigate the influence of numerous system parameters on product detection.

Keywords: frequency response; avalanche diode; amplifier; detector; Microwave amplitude modulated optical vibration .

The article presents the results of experimental investigations of carbon fabric electrodes for recording electrical biosignals. Experimental studies of carbon fabric electrodes showed good results both in conductivity and usability, for example, for further integration into clothing, that indicates the high quality of carbon fabric electrodes and promising for further uses for cardiac monitoring.

Keywords: Electrodes, carbon fabric, electrical biosignals, cardiac monitoring.

There is an important task to improve timber complex. It is a search of efficient using wood. The research results of energy reserves capacity running on a regularized round timber production technological line for wood construction are given in the article. The research suggests that 40 – 45 percent wood resources using on regularized round timber production technological lines are waste. This capacity can use for manufacturing different energy products: firewood, chip fuel, fuel pellets, fuel briquette. The research made on the plant (limited liability company “Biogrant”) in Karelian Republic.

Keywords: Woodworking, cylindering, technological line, wood costraction, energy reserves, fuelwood, firewood, chip fuel, fuel pellets, briquette

Calculation of coefficient of operating conditions of the pipeline is presented in article for the West Siberian region. Dependence of service life of the pipeline on this coefficient is presented. The data of samples witnesses received in laboratory of nondestructive control, confirming relevance of this subject are provided.

Keywords: corrosion, wall thickness, standard service life, pipeline, coefficient of working conditions, diameter, pressure, settlement resistance.

the problems of moisture (cooling) in the mass-transfer apparatus at different parameters of fluid spray and varying the magnitude of the influence of the electric field in the zone of the spray.

Keywords: heat and mass transfer, mist dispersion, electroaerosol, electrostatic dissipation.

This article discusses the problems of  retail network in Russia and the main directions of development of the domestic networks in connection with the expansion of foreign networks and Russia's WTO accession. In the harsh conditions of competition will survive only those commercial enterprises that will   practically use logistic as business philosophy and methodology, and  the main provisions of logistics management in  their business practice  

Keywords: Retail network, development of retail network, Logistizatcija retail network problems network retail, logistics strategy, logistics management

It is considered questions of automation of the productions, directed on increase of efficiency of the operating enterprises and the organisation of the new enterprises providing decrease of losses of wood resources, expenses of energy and time at all stages industrial forest exploitation. Descriptions of the developed algorithm and a method of automated management are resulted by processes and information streams of the wood enterprises

Keywords: The automated control systems, modelling methods, algorithm, processes industrial forest exploitation

The methods of construction and repair of temporary winter roads, proposed technical solution for creating devices that provide a significant increase in strength, bearing capacity and durability of the repaired snegoledovogo cover winter road at full mechanization of the process of recovery.

Keywords: Winter road, a temporary winter road, moisturizing, repairing, mechanized complex snow mass, milling machine, load capacity

A timber industry complex is a complex of technological processes linked with timber harvesting, wood transport and woodworking. For their optimization are used mathematical and economic methods. The brief overview of the application of mathematical modeling methods for the analysis and optimization of technological processes in the forestry sector is given in the article. Queuing theory is used for analysis of forestry process. For example harvesting technology with the round logs production for wooden construction is considered as G/G/1 queuing system. Well-developed models of queuing theory are recommended for analyzing of forestry process. Simulation models are recommended for deep analysis of forestry process.

Keywords: Forestry process, woodworking, cylindering, queuing theory, timber industry manufacture, wood construction

The paper contains a description of a new method for automatic generation of maps of goods placement. Map of goods placement created by the author's search algorithm. The algorithm is based on ideas of evolutionary search. The proposed algorithm works with a population of constant size, allows not use complex search methods and for a reasonable time find a solution close to the optimum.

Keywords: simulation, evolutionary computation, multicriteria optimization, genetic algorithms